Every Voice

Connect a mixer or sound board

A direct feed from your sound system gives far better captions than a microphone in the room.

Time15 minutes
You'll needA mixer, and a USB audio interface or a mixer with USB out

Find an output you can use

Look for an aux send, a matrix output or a USB output on your mixer. Pick one where you can control what goes in, so you can leave out music.

Connect it to the computer

Run a cable from that output to your USB audio interface and plug the interface into the computer. If your mixer has USB, a single USB cable does both jobs.

Build a speech-only mix

Send only the speech microphones to that output. Music on the feed can come through as nonsense captions. If you can't separate them, you can use Pause voice during music.

Select it in the studio

On the Live page, leave Audio source on Microphone and pick your interface under Input device. If it isn't listed, allow the microphone for this site and reload.

Turn off the processing

Open More options and turn off Echo cancellation, Noise suppression and Automatic volume. Your mixer has already handled this, and doing it twice harms the sound.

To make these the default, set them under Settings, Studio defaults.

Set your level

Press Test microphone and have someone speak at their normal volume until the test ends. The bar should move freely and rarely reach the far right. If the studio says the sound is too quiet or distorted, adjust the gain on your interface or the level of that output, not the speaker's main channel, and test again.

Do a real test

Start a session and let someone talk for a few minutes. Read the captions. If they're good, you're done. If they aren't, see Audio setup.